· Turbosmart Manual Boost Controllers Tee Installation Tutorial How-To Installwww.doorway.ru · Insert the cable into the back of the knob assembly provided in your Evolution boost controller package. Tighten the hex screw with the tool provided. MOUNTING: Locate the mounting strap in your package and mount your boost controller in a safe spot away from any moving parts. We mounted ours on the fan shroud of this particular car. · External Wastegate Setup. Allow the engine to cool down before installing your boost controller. Locate the bottom port on the external wastegate and the pressure source port. Install the Boost Tee in the wastegate pressure line with the wastegate arrow pointing towards the bottom port on the Estimated Reading Time: 3 mins.
Boost pressure can be bled off in a few ways, using a mechanical bleeder type system with a needle and a seat, a small opening or bleed hole, or the more reliable and accurate way using an electromechanical solenoid. Manual Boost Controllers Starting with one of the simplest forms of boost control, lets look at a Manual Boost Controller. 1= top port on controller. 2= Bottom port on controller. 3=left side of other peice. 4= Top side of other peice. 5= Right side of Other peice. 6= actuator. 7= boost source. Mitsubishi Eclipse GSX. Manual. When you're all done, connect the battery and boost controller (as per the controller's manual) and turn the key "ON" to make sure everything is hunky-dory. Connect the ECU harness connector while screwing in the 10mm bolt that secures it. Gradually alternate between tightening the bolt and pushing on the harness connector.
Just run the vacuum line from the wastegate into the boost controller, then from the boost controller somewhere in the IC piping. The dual stage is still the same, it just has 2 controllers and one is electric, with a switch. Turbosmart Manual Boost Controllers Tee Installation Tutorial How-To Installwww.doorway.ru Install the Boost Tee in the wastegate pressure line with the wastegate arrow pointing towards the bottom port on the wastegate. Secure all silicone hose ends with hose clamps. Mount your boost controller bracket onto the vehicle, then attach the boost controller onto the bracket with the supplied screws. Make sure the boost dial is turned.
0コメント